Home Improvement: Four Essential Tips for Bathroom Plumbing

The bathroom is a critical space in the home. Its improvement could translate into higher property value and increased comfort and efficiency for residents. Therefore, if you are planning for a renovation project, you should think about remodelling the space. In particular, you should improve the plumbing network. Efficient piping and features will mean efficiency and space appeal. Here are some practical tips for promoting successful bathroom plumbing improvement in your bathroom design.

Conceal Your Piping

When renovating your bathroom plumbing, you should plan for the concealment of the pipework. In general, your space will have numerous pipes, including cold water supply, heated water channels and drainage pipes. If these remain visible, they will make the room look cluttered. Moreover, exposed pipes are more vulnerable to damage. Therefore, you should spend a little more money to have the floors and walls opened for a clean and sleek look.

Choose Flexible Piping

You should choose piping and fittings which can be retrofitted in the future if you need to perform repairs or replacements. Poor choice of piping can make the process of making improvements or changes difficult. Typically, plastic fittings are easier to work with and they can be retrofitted without complications. These units will allow the treading of flexible pipework without the need for joints. Also, you can use plastic fittings to join copper and plastic pipes.

Improve the Waste Pipe

If your bathroom has a bad smell, the problem could be in the waste piping. In some cases, the waste pipes can pull air from surrounding waste traps in the place of vent pipes. As a result, there will be an unpleasant wastewater smell from the trap and a gurgling noise in the bathroom. Fortunately, this problem can be prevented by making some improvements to the wastepipe. Ideally, you should install anti-siphon valves or traps in the channel to block the unusual air and wastewater movement.

Check Your Pressure

You should check the water pressure in your home before installing new bathroom fixtures. The information is useful because there multiple plumbing fixtures which cannot operate efficiently when the pressure is too low. For example, some showers and tap mixers will require high water pressure. So, you should confirm that your water supply can match the demands of the fixtures you plan to install. If they cannot, you might need to plan for pressure boosting.

Finally, you should not move the positions of your main bathroom elements such as the toilet and bathroom significantly. Changing up the entire plumbing network will be expensive.

Share